Modules
logiR-GMSL2C-295A-296A-V3 – GMSL2 Video Module with HDR ISP processing

- 2-Ch video inputs/outputs
- based on the Maxim Integrated GMSL2 automotive serial interface
- hosts two separate deserializers allowing simultaneous and independent camera control and higher data throughput
- I2C tunneling, ECU or logiRECORDER camera initialization
- Rosenberger FAKRA connectors
- HDR ISP video processor (on/off by SW)
- Lossy video compression (on/off by SW)
- ISP tuning for specific video camera
logiR-GMSL2C-717F-716A – GMSL2 Video Module

- 2-Ch video inputs/outputs
- based on the Maxim Integrated GMSL2 automotive serial interface
- hosts two separate deserializers allowing simultaneous and independent camera control and higher data throughput
- I2C tunneling, ECU or logiRECORDER camera initialization
- Rosenberger FAKRA connectors
logiR-GMSL2C-295A-296A-V2 – GMSL2 Video Module

- 2-Ch video inputs/outputs
- based on the Maxim Integrated GMSL2 automotive serial interface
- hosts two separate deserializers allowing simultaneous and independent camera control and higher data throughput
- I2C tunneling, ECU or logiRECORDER camera initialization
- Rosenberger FAKRA connectors
logiR-SYNC – Time Synchronization Module

- integrates the Clock Sync input and the Clock Sync output driver
- compliant with PPS – GPS Pulse Per Second synchronization signal
- HW synchronization of stacked units
- time synchronization of remote test fleets
logiR-CONN2 – Power Microcontroller CAN OBDII Interconnection Module

- enables logiRECORDER’s power supply controls based on vehicle CAN OBDII communication
logiR-CONN1 – FlexRay Interconnection Module

- routes FlexRay signals through I/O modules to Low-Speed and Mid-Speed Vehicle Network connectors C1 and C2
logiR-OABR4 – 4-Port Open Alliance BroadR-Reach High-Speed Network Module

- based on the NXP SJA1055TLA Ethernet switch
- programmable regulated power supply for each BroadR-Reach input – 5-12V max 750mA
- egress tagging support
logiR-1GETH3 – 3-Port 1G Ethernet High-Speed Network Module

- based on the NXP SJA1055TLA Ethernet switch
- IEEE 802.3 compliant, 128 kB frame buffer, 1024 entry MAC address dynamic learning table
- per port configurable network speed: Auto-negotiation, 10Mbps, 100Mbps, 1000Mbps
- egress tagging support
logiR-SMARTE-1GETH4 – 4-Port 1GbE Smart Ethernet Network Module

- based on the Atom E3940 processor and four i210 Ethernet MAC, PHY and RJ45 connectors
- Jumbo frames, Interrupt moderation, VLAN support, Checksum offload
- PCI OBFF, RSS, MSI-X to lower CPU utilization
- four receive and four transmit queues
- software support available for accelerated industry popular TAPI processing
logiR-ADIO – Analog, Digital I/O and Microphone Input Module

- multipurpose board
- supports 3 digital I/Os, 1 differential or unipolar analog input, and 1 microphone input
- ADC input – measure different analog values from the test-vehicle
- DIGITAL IO – sense or activated I/Os at the automotive and other voltage levels
- MIC INPUT – for audio notification of logged events
logiR-FLEX2 – 2 Dual-Channel FlexRay Module

- 2 Freescale NXP controllers MFR4310
- FlexRay channels driven via the NXP TJA1080A PHY
- signals terminated by 100 Ohm termination resistors
logiR-UART – 2-Channel UART Module

- integrated two RS232 channels, up to 460kb/s, with the ADM3202ARN PHY from Analog Devices
- supports TX and RX signals only
logiR-LIN – 2-Channel LIN Module

- integrated 20kb/s TPIC1021DRG4 PHY from Texas Instruments
logiR-CANSW – 2-Channel CAN SW Module

- integrated CAN2.0B single wire 33kb/s or 83kb/s NCV7356 PHY from On Semiconductors
- CAN line terminated by 5K6 Ohm termination resistors
logiR-CANLS – 2-Channel CAN LS Module

- integrated CAN2.0B low speed 125kb/s TJA1055T PHY from NXP Semiconductors
- CAN lines terminated by 5K6 Ohm termination resistors
logiR-CANFD – 2-Channel CAN FD Module

- integrated CAN 2.0C 5.0 Mb/s TJA 1049T PHY from NXP Semiconductors
- CAN High Speed support
- programmable 120 Ohm termination software controlled through the logiRECORDER Dashboard
logiR-AURORA-DS25BR110 – Aurora Video Module

- based on the TI DS25BR110 LVDS buffer
- Aurora 8b/10b protocol specification v2.3 compliant
- up to 12 independent Aurora lanes
- general-purpose data channels with a fixed throughput of 320 Mbps
logiR-GMSLC-705-706 – GMSL Video Module

- 2-Ch video inputs/outputs
- based on the Maxim Integrated GMSL MAX96705 serializer and the MAX96706 deserializer
- I2C tunneling, ECU or logiRECORDER camera initialization
- Rosenberger FAKRA connectors
logiR-FPD3C-933-934 – FPD-Link III Video Module

- 2-Ch video inputs/outputs
- based on the TI FPD Link-III DS90UB933 serializer and the DS90UB934 deserializer
- I2C tunneling, ECU or logiRECORDER camera initialization
- Rosenberger FAKRA connectors
logiR-FPD3C-953-954-V2 – FPD-Link III Video Module

- 2-Ch video inputs/outputs
- based on the TI FPD Link-III DS90UB953 serializer and DS90UB954 deserializer end-point and tap-modes enabled
- hosts two separate deserializers allowing simultaneous and independent camera control and higher data throughput
- I2C tunneling, ECU or logiRECORDER camera initialization
- MIPI – CSI-2, 4 Lanes 832Mbs, I2C up to 1 Mbps
- Rosenberger FAKRA connectors
- video compression support coming soon
logiR-HDMI-511-613 – Single-Channel HDMI Video Module

- 1-Ch video input/output
- based on the HDMI ADV7511W transmitter and the ADV7613 receiver from Analog Devices
- programmable 2-way color space converter
Ordering information
Product name | Product number | Description |
---|---|---|
logiR-GMSL2C-295A-296A-V3 | 61-02013-22-00001 | GMSL2 295A/296A Two Channel Video Module, v3 |
logiR-GMSL2C-717F-716A | 61-02009-20-00001 | GMSL2 two-channel video Input/Output module |
logiR-GMSL2C-295A-296A-V2 | 61-02006-20-00001 | GMSL2 two-channel video Input/Output module |
logiR-SYNC | 61-04001-18-00001 | Synchronization module |
logiR-CONN2 | 61-01008-19-00001 | Power Microcontroller CAN OBDII Interconnection module |
logiR-CONN1 | 61-01007-19-00001 | FlexRay Interconnection module |
logiR-OABR4 | 61-05002-18-00001 | BroadR Reach module |
logiR-1GETH3 | 61-05001-18-00001 | Ethernet module 2xMAC-3x1000T |
logiR-SMARTE-1GETH4 | 61-05006-19-00001 | Smart Eth. Module AtomE3940 + 4 1Gb Ethnernet |
logiR-ADIO | 61-03001-18-00001 | Analog and Digital IO module |
logiR-FLEX2 | 61-06001-18-00001 | FlexRay two dual-channel (A & B) interfaces module |
logiR-UART | 61-01001-18-00001 | UART two-channel module |
logiR-LIN | 61-01002-18-00001 | LIN two-channel module |
logiR-CANSW | 61-01006-18-00001 | CAN SW module |
logiR-CANLS | 61-01004-18-00001 | CAN LS two-channel module |
logiR-CANFD | 61-01003-18-00001 | CAN FD/HS two-channel module |
logiR-AURORA-DS25BR110 | 61-02007-20-00001 | TI DS25BR110 12-channel Aurora Input module |
logiR-GMSLC-705-706 | 61-02003-18-00001 | Video Max 96705/96706 two-channel Input/Output module |
logiR-FPD3C-933-934 | 61-02001-18-00001 | Video TI x933/934 two-channel Input/Output module |
logiR-FPD3C-953-954-V2 | 61-02008-20-00001 | Video TI x953/954 two-channel Input/Output module |
logiR-HDMI-511-613 | 61-02005-18-00001 | HDMI single-channel Input/Output module |